Division 03
Industrial Automation
Control systems for plants and utilities: instrumentation, PLC, SCADA and drives.
MEENTAKA designs, programs and commissions control systems, from field instruments and PLC logic to SCADA in the control room. Modernization of existing systems is done in stages agreed with production, and documentation is handed over so the plant can maintain the system itself.
The control loop
Simulation · not live footage · drag to turn
- 01SensorMeasures the process: position, temperature, pressure, speed.
- 02ControllerA PLC executes the control logic.
- 03Industrial networkCarries signals between devices (PROFINET, EtherNet/IP, Modbus, OPC UA).
- 04Supervisory systemSCADA and HMI show the state of the process and set targets.
- 05ActionActuators act on the equipment, and the sensor measures the result.
Conceptual diagram. It shows the principle, not a specific installation.
What MEENTAKA delivers
- Control system design and I/O lists
- PLC and SCADA programming and commissioning
- Modernization of relay and obsolete PLC systems
- Automation of pumping stations and hydraulic structures
- Remote monitoring of wells and field facilities
Integrates with
- PLC and distributed I/O
- SCADA and HMI
- Industrial networks (Modbus, PROFINET, EtherNet/IP, OPC UA)
- MES
Applied by industry
- Process control for crushing and grindingCrushers and mills are run from local panels, so feed rate and load vary by shift and overloads stop the equipment.
- Automation of wellsites and gathering facilitiesWells and gathering points are checked by field crews, so deviations in pressure and flow are seen late.
- Automation of hydraulic structuresGates and regulators are operated by hand, so distribution follows schedules rather than actual demand.
- Line automation and modernizationOlder lines run on relays or obsolete PLCs; spare parts are scarce and changes take long.